Tag Archives: Autotransformer

40-20-15 EFHW

Here are the 24 hour WSPR results on 40-20-15m receive using band hopping. They appear to be pretty consistent with current band conditions and while not as good as the 1/4 wave vertical it is a very respectable and very portable multi-band antenna.

40m40m

20m20m

15m15m

The SWR plot is as follows:

swr

These antennas are increasingly popular and many quality antennas sell for ~$140. Building your own is very simple and I would estimate my cost to build this would not be greater than $30. This will work out to be a good antenna for portable or field day use. It is not especially sensitive to mounting or orientation.

 

Advertisements

EFHW Broadband Transformer On the Air

Back in late August, I had a post regarding a broadband auto transformer for an EFHW antenna. I finally got around to cutting 66ft of wire (1/2 wave on 40m) and did some basic tests. It is only up about 10 ft and stretched out north-south across the back yard. The RigExpert Zoom showed dips in the 40m, 20m & 15m bands. SWR is below 2:1 across each band. Twenty-five feet of coax forms the counterpoise. Very promising. One SSB contact on 20m yielded a 57 report on this antenna and the 1/4 wave vertical. I am running WSPR now on 40m. Tomorrow I will raise this up to a least 20ft and run some more tests. If I add another 66ft it will be a 1/2 wave on 80m and should get me a match on all bands (except 60m) between 80m and 10m.

Antenna Experiments Continue

First up is a broadband EFHW using an auto-transformer wound on an FT240-43 Ferrite toroid. I used 18 gauge doorbell wire (had to remove the outer jacket of the wire pair first. The basic wiring looks like this (thanks to PA3HHO):

2017-08-31_10-40-14

What is not shown here is a 150pF capacitor across points A & B. Here is the completed toroid:

20170831_153149704_iOS

Here I test the matching by connecting a 3.9KOhm resistor across point B & C along with the 150pF capacitor across A & B. Here is the SWR plot:

20170831_153018134_iOS

SWR is below 2:1 across nearly the entire band 80m to 12m 10m is 5:1 well within range of a tuner. I will mount this in a box with a UHF connector and two banana jacks, One for the antenna wire and the other as a ground connection. Once complete I’ll try first with 40m 1/2 wave wire. That should give me a good match on 40m, 20m, and 15m. The wire will be around 66 ft long.  I should be able to add 80m by adding a loading coil and an additional 2.5m piece of wire. Planning to un the first 10m of wire up the travel mast then bring the rest down as a sloper.